Changhong LED32E2200ST2 Manual Del Usuario página 19

Menu Operation
Signal Type is Satellite:
■ Auto Tuning
Press the ENTER/►button to enter sub-menu.
Country: Press the◄/►button to select country.
Satellite: Press the ◄/► buttons to select current satellite.
Scan Mode: Press the ◄/► buttons to select Scan Mode: Default, Blind Scan,
Network.
Channel Type: Press the◄/►button to select channel type: Scramble,
Free+Scramble, Free.
Service Type: Press the◄/►button to select Service Type: All, DTV, Radio.
Start: Press the ENTER button to start the auto searching.
Dish Setup(only in satellite mode)
■
- Satellite/Transponder: Press the ▲/▼ button to select the Satellite. press the
EPG button to select the transponder.
Press the ▲/▼ button to select the satellite/transponder from the list.
Delete: Press the red button to delete the current satellite/transponder.
Edit: Press the green button to edit the current satellite/transponder.
Add: Press the yellow button to add a new satellite/transponder.
Scan: Press the blue button to enter sub-menu.
• Scan Mode: Press the ◄/► buttons to select Scan Mode: Default, Blind Scan,
Network.
• Channel Type: Press the◄/►button to select channel type: Scramble,
Free+Scramble, Free.
• Service Type: Press the◄/►button to select Service Type: All, DTV, Radio.
-LNB Type: Select the LBN type.
-LNB Power: Select the power supply type for the LBN.
-22KHz: 22KHz SWITCH. Select the mode: On, Off, Auto.
-Toneburst: You can choose one of two satellites. Used to choose proper device.
-DiSEqC1.0: You can choose one of four satellites. Used to choose proper
device.
-DiSEqC1.1: You can choose one of sixteen satellites. Used to choose proper
17