Connection And Setup - Changhong LED32E2200ST2 Manual Del Usuario

Connection and Setup

1. PC: Connect one end of the VGA cable with the VGA port on computer, connect the
other end of the VGA cable with the VGA port on the TV, and tighten the bolts
clockwise on the each end of VGA cable.
NOTE:
 While connecting the 15-pin VGA, please do not insert the plug overexerted, for
fear the pin might be broken.
2. SCART: Connect SCART socket input or output from an external device to these
jacks.
3. ANT(1,2): Used to connect the antenna or the cable TV network, and receive outdoor
antenna signals or closed circuit TV signals.
4. HDMI(1,2,3): Support AV devices with an HDMI connector (such as set top box,
DVD player, digital TV set, etc.).HDMI is also called as high definition multimedia
interface, and it can transmit digital audio and video signal with one cable.
NOTE:
 While connecting the HDMI, please aim at carefully, do not insert overexertedly,
for fear the pin might be broken.
5. DIGITAL AUDIO OUT: Sending the TV's digital audio signal to external audio
equipment via the Digital Audio Output port.
6. AV IN: The output AV terminal of DVD can be connected with the AV input port of
the TV through AV cable.
7. COMPONENT(YPbPr):The output COMPONENT(YPbPr) terminal of DVD can be
connected with the COMPONENT(YPbPr) input port of the TV through AV cable.
NOTE:
 Both Audio signals of AV and COMPONENT are input from "R - Audio - L".
 If COMPONENT (YPbPr) and AV works as mini terminal, and shared same audio,
Please choose to use a one-to-three audio &video cable.
8. CI: Please insert CI card into the PCMCIA slot according to the arrow on the CI card.
9. USB: USB port, used to connect USB devices, such as USB Disk.
: Connect it to your headphone or other audio equipment.
10.
11. Connect the power cable with 100-240V~ power supply.
NOTE:
 The range of power input for the TV is 100-240V~ 50/60Hz; Do not connect the
TV power input port with the power cable out of the above range.
Connection Installation
7