Tabla de contenido
Publicidad
FÖRSVARETS MATERIELVERK
R&S IN4000A
2.2.2 Removal
Remove power supply in reverse order of installing it.
User Manual 6105.5822.02 - 02
TEKNISK ORDER DRIFT
e) Press the automatic unlocking device and pull the innermost slide completely
out.
f)
Attach the innermost slide to the left-hand side panel of the power supply with
four Phillips screws and the associated washers. Screws must not penetrate
unit by more than 6 mm.
g) Take the outer telescopic slides and mount them to the rack.
h) Insert the power supply, with its slides fitted, into the extended slides of the
rack and slide it in until the stop is reached.
i)
Fasten the power supply to the rack using four screws.
DF SAMBAND 100 023032
Preparation for Use
Installation and Removal
11
Publicidad
Tabla de contenido
