Operation; Switching The Power Supply On; Switching The Power Supply Off; Figure 9: Front View Of R&S In4000A - Rohde & Schwarz R&S IN4000A Manual Del Usuario

FÖRSVARETS MATERIELVERK
R&S IN4000A

3 Operation

3.1 Switching the Power Supply On

Before turning on make sure that there is no battery charging voltage
connected to BATT IN (X3) that exceeds 27.6V!
In the case of high relative humidity and a significant temperature difference
between the power supply and surrounding air, considerable amounts of water
may condensate on the power supply.
Make sure power supply is dry before installing it.
Figure 9: Front View of R&S IN4000A
For turning on the power supply bring mains switch on the front plane to position "I"
(see Figure 9).
If supply voltage is sufficient LED "TEST" lights up.

3.2 Switching the Power Supply off

For turning off the power supply bring mains switch on the front plane to position "0".
LED "TEST" will turn off.
User Manual 6105.5822.02 - 02
TEKNISK ORDER DRIFT DF SAMBAND 100 023032
Operation
Switching the Power Supply On
17