Brink 6606 Instrucciones De Montaje página 6

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 10
hout fully tightening.
6. Position support G and attach it at point H, then fit the whole thing wit-
hout fully tightening.
7. Position support I and attach it at point J, then fit the whole thing wit-
hout fully tightening.
8. Fit the cross beam K between supports C, D, E and I at points L and M
and fit the whole thing finger-tight.
9. Fit the Brink Connector N, including foldaway socket plate O and brac-
ket P at points Q.
10. Tighten all nuts and bolts to the torque indicated in the drawing.
11. Please note: if present: Fit the part indicated. Fit the spare wheel.
See fig 1.
12. Place the sticker according to figure 2.
For dismantling and fitting the vehicle parts, see the site handbook.
For fitting instructions and attachment method, see drawing.
See the assembly manual supplied for instructions on fitting the remo-
vable ball system.
NOTE:
* Should this installation process entail the cutting of the bumper – confor-
mation MUST be obtained by the installation engineer of the customer's
acceptance prior to completion. Brink Towing Systems do not accept res-
ponsibility for any matters arising as a result of this miscommunication.
* All measurements are in mm!
* The dealer should be consulted for possible necessary adjustment(s) "of
the vehicle".
* Remove the insulating material from the contact area of the fitting
points.
* Consult your dealer for the maximum tolerated pull weight and ball hitch
pressure of your vehicle.
* Do not drill through electrical-, brake- or fuellines.
* Remove (if present) the plastic caps from the spot welding nuts.
* This fitting instruction has to be enclosed in the vehicle documents after
fitting the towbar.
* Brink is not liable for damage caused directly or indirectly by incorrect
assembly, including the use of unsuitable tools, the use of other assem-
bly methods and means than the ones outlined, and the incorrect inter-
pretation of these assembly instructions.
D
MONTAGEANLEITUNG:
Vor Beginn des Einbaus ist anhand der Typplakette der Anhänger kupp -
lung festzustellen, welche Einbauskizze in dieser Montageanleitung
die richtige ist.
1. Achtung, wenn vorhanden: Das Ersatzrad abmontieren. Siehe
Abbildung 1.
2. Die Originalschrauben an den Punkten F und J entfernen.
3. Die Halterungen A anlegen und bei den Punkten B befestigen. Alles
halbfest montieren.
4. Die Halterung C anlegen und bei das Punkt D befestigen. Alles halbfest
montieren.
5. Die Halterung E anlegen und bei das Punkt F befestigen. Alles halbfest
montieren.
6. Die Halterung G anlegen und bei das Punkt H befestigen. Alles halbfest
montieren.
7. Die Halterung I anlegen und bei das Punkt J befestigen. Alles halbfest
montieren.
8. Den Querträger K zwischen den Halterungen C, D, E und I bei den
Punkten L und M halbfest anbringen.
9. Den Brink Connector N einschließlich wegklappbarer Steckdosenplatte
© 660670/24-04-2020/6

Publicidad

Tabla de contenido
loading

Tabla de contenido