Using The Laser - DeWalt DW083 Traducido De Las Instrucciones Originales

• Extreme temperature changes cause movement of internal parts that may affect
the accuracy of the tool. Regularly check the accuracy while using the tool under
these circumstances.
• Although the tool corrects small out-of-level errors automatically, when it is bumped,
re-adjustment to balance or set-up may be required.
• If the tool has been dropped or has tipped over, have the laser head calibrated by a
qualified repair agent.
Low Battery Indicator (Fig. B)
The DW083/DW083CG is equipped with a low battery indicator
The red indicator light is located on top of the tool. When the light flashes, the batteries
are low and need to be replaced. The laser may continue to operate for a short time while
the batteries continue to drain. After fresh batteries are installed and the laser is turned
on again, the red indicator light will stay off. (A flashing laser beam is not caused by low
batteries; refer to Out of Tilt Range Indicator.)
Turning the Laser On and Off (Fig. A)
With the laser off, place the tool on a relatively smooth, stable, and level surface.
Turn the laser on by rotating the on/off lever
beams; one up 2 , one down
To turn the laser off, rotate the on/off lever
longer be projected.
Locking Pendulum
The DW083/DW083CG is equipped with a locking pendulum mechanism. This feature is
only activated when the laser is switched off. When the on/off lever is rotated to the ON
position, the pendulum will be released from the locked position and self-level.

Using the Laser

The beams are level or plumb as long as the calibration has been checked (refer to
Field Calibration Check) and the laser beam is not flashing (refer to Out of Tilt Range
Indicator).
The tool can be used to transfer points using any combination of the three beams.
Integrated Magnetic Pivoting Bracket (Fig. A)
The DW083/DW083CG has a magnetic pivoting bracket
unit. This bracket allows the unit to be mounted to any upright surface made of steel or iron
using the magnets 7
suitable surfaces include steel framing studs, steel door frames and structural steel beams.
3 , and one horizontal
1
located on the back of the pivoting bracket. Common examples of
5 , as shown in figure B.
1 so it points up. It will then project three
4 .
down to its horizontal position. Beams will no
6 permanently attached to the
EnGLIsH
35