Prepare The Receiver Collar - Petsafe PIF45 Manual De Adiestramiento Y Funcionamiento

STEP 3

Prepare the Receiver Collar

Your Receiver Collar comes with short Contact Points installed. Use the long Contact
Points for pets with long or thick hair. Tighten the Contact Points using the Contact
Point Wrench (3A). Check the tightness weekly.
Turning the Receiver Collar On
Press and hold the Mode Button continuously for 5 seconds (3B). The green or
yellow or red Receiver Indicator Light will turn on for 5 seconds (3C) to indicate
battery status, followed by the red Receiver Indicator Light flashing the Static
Stimulation Level Settings.
Turning the Receiver Collar Off
Press and hold the Mode Button continuously for 5 seconds.
The red Receiver Indicator Light will be on during this time.
The red Receiver Indicator Light will then turn off and all Receiver Indicator Lights
will stay off indicating that the unit is turned off.
To extend the time between charging the Receiver Collar, consider turning off the
Receiver Collar when it is not in use.
10 www.petsafe.net
3A 3A
3B
Mode
Button
3C