Operating Guide; Set Up The Transmitter - Petsafe PIF45 Manual De Adiestramiento Y Funcionamiento

STEP 1

Set Up the Transmitter

Important: You may need to move the Transmitter several times before determining the final location.
The Transmitter is located at the exact centre of the desired Pet Area. Place the Transmitter:
• On the ground floor of your home and at least 60 cm above the floor.
• In a dry, well ventilated, protected area.
• In an area where temperatures do not fall below -12 °C (e.g., garage, basement, shed, cupboard).
• On a non-metal table or other hard surface to ensure proper ventilation (1A).
• Do not place anything on top of Transmitter or cover any ventilation holes. This may
overheat the Transmitter and cause early Transmitter failure.
• Do not place Transmitter in a closet or any other confined, unventilated area.
• Do not place Transmitter on or near a metal surface.
• At least 1 m from large metal objects, as these items may reduce the size and shape of your Pet Area (1B).
Placing the Transmitter inside a metal building or shed can reduce the maximum range of the Stay + Play
Wireless Fence™ system.
The Transmitter has three built in warning alarms: a Power Loss Alarm, a Metal Interference Alarm, and a
Transmission Failure Alarm.
• The Transmitter Power Loss Alarm sounds an intermittent
single tone alarm indicating power has been removed from
the Transmitter. The Power Loss Alarm will last up to 30
minutes. In the event of a power loss, your pet is no longer
contained.
There are three ways to turn off the Power Loss Alarm:
1. Plug Power Adaptor into a functional standard AC
outlet.
2. Unplug Transmitter Power Adaptor from the Power
Jack located on the bottom of the Transmitter.
3. Press the Alarm Disable button for 5 seconds then release. Three short tones will sound to signify the
alarm has been turned off.
• The Metal Interference Alarm sounds an intermittent double tone alarm indicating that the Transmitter has been
set towards the maximum range and placed on or close to a metal surface. If the Metal Interference Alarm
sounds, your pet is no longer contained. You must relocate the Transmitter away from metal or the alarm will
continue to sound and the transmission from the Transmitter will remain disabled.
8

OPERATING GUIDE

www.petsafe.net
1A 1B
Wall
Mount
Tabletop
1 m