Pair The Receiver Collar For One Dog Operation; Pair The Receiver Collar For Two Dog Operation - Petsafe VT-800 Manual De Funcionamiento

STEP 4
Pair the Receiver Collar for One
Dog Operation
To pair the Receiver Collar to work with a new Handheld Transmitter
or to pair a new Receiver Collar to work with your existing
Handheld Transmitter:
1. Turn the Receiver Collar off.
2. Press and release the Transmitter's Dog Select Button and ensure
the Red LED flashes one time to indicate Dog 1 is set.
3. Press and hold the On/Off Button continuously for 5 seconds. The
Green LED flashes once every second after the button is released
and waits to receive an ID for up to 10 seconds.
4. Press and release the Top Button (light blue) once during the 10
second programming mode. (This sends the Transmitter's unique
ID to the Receiver.)
5. When the Green LED light on the Receiver Collar flashes 5 times,
the new ID has been received. This can be verified by pressing
the Top Button (light blue) on the Transmitter.
6. If the Receiver Collar does not receive the new ID, it will
automatically exit the pairing mode and retain its previous ID.
STEP 5
Pair the Receiver Collar for Two
Dog Operation
For a 2 Dog System, additional Receiver Collars are available at
www.petsafe.net or through our Customer Care Centre. For a listing
of Customer Care Centre telephone numbers, visit our website at
www.petsafe.net.
www.petsafe.net 15