Fit The Receiver Collar - Petsafe VT-800 Manual De Funcionamiento

STEP 3

Fit the Receiver Collar

Important: The proper fit and placement of your Receiver Collar
is important for effective operation. The Vibration Points must have
direct contact with your dog's skin on the underside of his neck.
Please refer to page 3 for Important Safety Information.
To assure a proper fit, please follow these steps:
1. Make sure that the Receiver Collar is
turned off.
2. Start with your dog standing
comfortably (3A).
3. Place the Receiver Collar on your dog's neck
close to the ears. Center the Vibration Points
underneath your dog's neck, touching the
skin (3B). Note: It is sometimes
necessary to trim the
hair around the
Vibration Points to
make sure that contact
is consistent.
4. Check the tightness
of the Receiver Collar
by inserting one finger
between the collar and
your dog's neck (3C).
The fit should be snug
but not constricting.
3B
Do not shave the pet's neck as this may increase
the risk of skin irritation.
3C
www.petsafe.net
3A
13