Reset The Receiver Collar; Program The Receiver Collar For Two Or Three-Dog Operation - Petsafe HDT11-13910 Instrucciones De Uso

Step 5

Reset the Receiver Collar

To reset the Receiver Collar to work with a new Handheld Remote or to reprogram a new
Receiver Collar to work with your existing Handheld Remote:
1. Turn the Receiver Collar off.
2. Press and hold the On/Off Button until the Receiver Indicator Light comes on solid green and
the Receiver Collar beeps low to high.
3. Continue to hold the On/Off Button until the Receiver Indicator Light has turned off.
4. Press and hold the Upper Button on the Handheld Remote until the Receiver Indicator Light
flashes 5 times and beeps 5 times. You may need to hold both units 3 feet from each other
before this occurs. Once the Receiver Indicator Light has flashed 5 times, the Receiver Collar
has been reset. If the Receiver Indicator Light does not flash 5 times, start again and repeat
the process.
Step 6
Program the Receiver Collar for Two or
Three-Dog Operation
With the Remote set to Mode 6, 7 or 8, PetSafe
upper, lower, or side Handheld Remote buttons. Add-A-Dog
train additional dogs.
1. Program the Handheld Remote to Mode 6, 7 or 8.
2. Program the first Receiver Collar.
a. Turn the Receiver Collar off.
b. Press and hold the On/Off Button. The Receiver Indicator Light will come on, then turn off
in 4-5 seconds. If the On/Off Button is released too early, the Receiver Indicator Light will
begin its normal flashing. If this occurs, start over and repeat the process.
c. After the Receiver Indicator Light has turned off, release the On/Off Button.
d. Press and hold the Upper Button on the Handheld Remote until the Receiver Indicator Light
flashes 5 times and beeps 5 times. You may need to hold both units 3 feet from each other. If
the Receiver Indicator Light does not flash 5 times, start over and repeat the process.
3. Program the second Receiver Collar following steps A. thru D. above, using the Lower Button
in place of the Upper Button.
4. Program the third Receiver Collar following steps A. thru D. above, using the Side Button in
place of the Upper Button.
10 Customer Care Center 1-800-732-2677
Receiver Collars can be set to respond to the
®
receiver(s) must be purchased to
®