Pool Pump Disassembly & Storage & Pump Removal Instructions For Troubleshooting - Polygroup SUMMER WAVES SKIMMERPLUS SFS350 Manual Del Propietário

POOL PUMP DISASSEMBLY & STORAGE
1. First, turn the pump off and unplug the main power cord of the system.
2. Remove the Skimmer Lock Top
section of the filter.
3. Loosen all Hose Clamps
4. Remove the Return Fitting
place them in a safe place.
5. Remove the Pump Motor Assembly
lowering it from the Skimmer Canister.
place it in a safe place.
6. Remove the Hex Head Screws
carefully remove the Face Plate
and dry all filter cartridges, place them in a safe place with the pump skimmer canister, pump, return hose, hose clamps and the wall fitting.
7. All items should be stored in a dry environment that remains above 32 degrees Fahrenheit at all times.
PUMP REMOVAL INSTRUCTIONS FOR TROUBLESHOOTING
IMPORTANT:
The recommended method to troubleshoot or replace the pump is to remove the entire filtration system. Please drain enough water from the
pool so that the water level is below the skimmer opening. Then remove the entire skimmer system following steps 1 - 6 on page 12.
REMEMBER TO KEEP ALL PARTS IN A SAFE PLACE FOR REASSEMBLY LATER
CAUTION:
If you prefer to leave the skimmer filtration system attached to the pool we recommend having two people available to follow the process below.
PLEASE NOTE: The incorrect handling method may cause damage resulting in water leakage between the canister and liner wall.
1. First, turn the pump off and unplug the main power cord of the system. (REMEMBER TO KEEP ALL PARTS IN A SAFE PLACE FOR REASSEMBLY LATER)
2. Remove the skimmer lock top, skimmer strainer basket and the filter cartridge and remove any chlorine tablets left inside the core section of the filter cartridge.
3. Unscrew the Locking Ring
remove the Return Fitting Diverter
(snap-on style) the Return Fitting Diverter
insert the Service Plug to block the water
while troubleshooting.
5. After removing the pump from the canister you can save your pool
water by carefully inserting the second service plug from the top of the
canister into the center hole at the bottom of the canister.
Should you encounter any problems, contact Customer Service at (888) 919-0070 from 8 AM to 5 PM Mon. thru Fri.
13
Skimmer Strainer Basket
. Remove the Return Hose
- and clean the parts. Lubricate the Fitting Gasket
by removing the Pump Mounting Screws
Now clean the pump, dry it off, and lubricate the O-rings
from the Skimmer Face Plate
, the Weir and the Faceplate Gasket
(threaded style) and
or unsnap
and
MST. Extended operating days and hours during peak season requirements.
and the Filter Cartridge and remove any chlorine tablets left inside the core
and allow the water to drain out.
with petroleum jelly and reassemble all parts then
using a Phillips Head screwdriver. Remove the pump
being sure to support the Pump Skimmer Canister
. Next remove the Pump Skimmer Canister
4. Caution this step takes two people.
Be prepared to get wet even if you have drained the pool to below the skimmer opening
as the canister may still contain water.
One person should hold the pump skimmer canister firmly in place while the other
person removes the pump from the bottom of the canister using a screwdriver to remove
the pump mounting screws.
DO NOT pull or push the canister as this may cause damage between canister and pool
liner wall.
OWNER'S MANUAL
on the pump with petroleum jelly and
from falling and
. Clean