Setup Instructions & Filter Pump Operation 9 - Polygroup SUMMER WAVES SKIMMERPLUS SFS350 Manual Del Propietário

Before assembling your product, please take a few minutes to check the contents and become familiar with all the parts.
WARNING:
CLIMBING HAZZARD! PLEASE PREVENT CHILDREN FROM CLIMBING ON THE FILTER CANISTER TO GAIN ACCESS TO THE POOL.
1. Set up the pool by following all the instructions that came with the pool. Do not
fill with water until the Filter Pump is properly installed. Locate the Skimmer
and Inlet openings on the pool wall.
Skimmer opening
Inlet
opening
7. Now locate the pump and lubricate the pump O-ring with petroleum jelly (not provided). This O-ring is located on the Volute Housing Inlet as
shown in Fig 2. Hold the Skimmer Canister
in the side of the filter case as shown in Fig. 2. Fasten the Pump Mounting Screws
skimmer canister as shown in Fig. 2.
8. Locate the Pool Wall Fitting assembly parts
the Pool Wall Fitting . Insert the pool wall fitting with the gasket through the hole in the wall from the inside of the pool.
9. Place the Return Fitting Washer
DO NOT over tighten the Return Fitting Lock Nut or wrinkle the pool wall around the Return Fitting Washer
10. Now apply some petroleum jelly to the thread of the Elbow 90°
Diverter and Locking Ring
11. Get the Return Hose and remove the two Hose Clamps
of the hose. It is recommended to lubricate the O-Rings
hose. Install the hose on the volute housing outlet and on the Elbow 90°
Should you encounter any problems, contact Customer Service at (888) 919-0070 from 8 AM to 5 PM Mon. thru Fri.
SETUP INSTRUCTIONS
IMPORTANT:
may result in the faceplate developing a leak because the screws have not been tightened
equally. Alternate tightening each screw an equal amount, each in sequence, until all are
equally tight and you have a good even seal.
Warning! Be sure not to over tighten the screws, you just need a water tight seal.
securely, and insert motor pump so that the outlet on the volute housing extends out of the opening
- . Lubricate the black Fitting Gasket
over the pool wall fitting and then thread the Return Fitting Lock Nut
onto the wall fitting.
on the Volute Housing Outlet (see Fig. 2) and on the Elbow 90°
MST. Extended operating days and hours during peak season requirements.
OWNER'S MANUAL
2. Remove the Skimmer Lock Top
inside.
3. Locate the mounting location for the power filter on the Pool Wall
4. Install one Gasket
canister and place it up to the outside of the pool wall.
NOTE: An extra gasket is included for your convenience.
5. Carefully insert the four alignment pins through the four large holes on
the pool wall skimmer opening. Now leaning against the skimmer to hold
it in place and add the Face Plate
pool wall.
6. Place the Hex Head Screws
Screws one and a half turns each. Proceed to tighten each screw, a few
turns at a time, equally in sequence around the Face Plate.
Do not tighten any screw fully. Tightening a screw too much on one side alone
by screwdriver (not provided) to attach the pump onto the
with petroleum jelly and install it over the threads on
and install the elbow into the wall fitting assembly. Install the Return Fitting
from the hardware bag. Loosen the hose clamps and slide them over the ends
. Tighten both of the Hose Clamps
and take out the parts contained
over the four alignment pins on the skimmer
over the pins on the inside of the
into the holes. Start all the Hex Head
onto the fitting until it is hand tight.
or Fitting Gasket .
before installing the
. See Fig. 3.
9