Facom 711 Guía De Instrucciones página 22

Measuring AC or DC currents
Disconnect the circuit and place the probe tips in parallel on the
circuit to be tested. Place the switch on the 10A ammeter function and
connect the red wire to the 10A terminal. Switch on the circuit and
read off the measured value. If the value is too small
place the switch on mA and connect the red wire to the
Press the /~
additional function keys MIN/MAX, RANGE,
«Additional function keys», page 15)
...
A and ~
Voltage drop (2)
Digital resolution
Bar graph resolution 1 mA
»AC» accuracy
(4)
»DC» accuracy
Protection (3)
(1) From 5A to 10A, to prevent overheating, limit the time of use to
10 minutes.
(2) Voltage drop at the terminals for 40 mA, 400 mA, 10 A.
(3) 600 mA for 30 seconds for the 400 mA range.
15 A for 30 seconds for the 10 A range.
(4) Use on frequencies : 40 Hz to 500 Hz.
22
key to select AC or DC. It is possible to use the
...
.
Unit ranges when measuring current
40 mA
600 mV
10 A
µ
± 1.5% Reading ± 2 pt
~
± 1.5% Reading ± 1 pt
...
0.4A HPC fuse
600 Volt
and
400 mA
4.5 V
100 A
µ
10 mA
(less than 400 mA)
+ terminal.
HOLD
(refer to
10 A (1)
600 mV
10 mA
1 A
± 2 %R
± 2 pt
± 1,5% R
± 2 pt
12A fuse
600 V HPC
: