Operation; Switching The Device On And Off; Setting The Heat Output; Selecting The Temperature - Silvercrest SHLF 2000 B2 Instrucciones De Servicio

6. Operation

Identical symbols on the buttons mean iden-
tical functioning. These instructions describe
the operation via the remote control 19.
The selected function is shown on the dis-
play 10.
As soon as the device is in operation, the
control lamp 18 lights up.
The device can be operated via the operating
panel 1 or via the remote control 19.
6.1 Switching the device on
and off
1. Insert the mains plug into a wall socket
corresponding to the technical data.
2. Switch the device on by setting the main
switch 9 to I.
The main switch 9 and the display 10
are lit up. The device is in standby
mode.
3. Put the device into operating mode by
pressing the standby button
control lamp 18 lights up.
4. In order to switch back to standby mode,
press the standby button
After a few seconds stopping time, the
device switches into standby mode.
NOTE: the device requires electricity in this
state.
5. In order to completely switch off the de-
vice, set the main switch 9 to 0.

6.2 Setting the heat output

• Press Mode 21 repeatedly until the de-
sired heat setting is shown on the dis-
play 10:

6.3 Selecting the temperature

• The button + 20 allows you to increase
the desired temperature up to 38 °C, while
the button - 22 allows you to reduce the
desired temperature down to 6 °C.
23. The
The selected desired temperature is shown
on the display 34.
The room temperature is measured by the
23 again.
temperature sensor 8 and shown on the dis-
play 33.
The device switches off automatically once
the room temperature has reached the de-
sired temperature. If the room temperature
falls below the desired temperature, the de-
vice automatically switches back on again.

6.4 Setting the running time

The device has a timer 24, with which you
can set the desired running time. The run-
ning time can be set at between 1 minute
and 23 hours 59 minutes.
Upon reaching the end of the running time,
the device switches off automatically and
End appears on the display.
Low heat output: device oper-
ates at 1,000 watt
High heat output: device oper-
ates at 2,000 watt
Automatic mode: the device au-
tomatically adapts the heat out-
put to the room temperature.
Frost protection: the device only
switches on at 6 °C ambient
temperature.
GB
51