Pioneer BCS-424 Manual De Instrucciones página 64

64 Advanced settings
En
 Registering or Changing the password
Use this procedure to register or change
the code number required for the Parental
Lock settings.
About default password of this unit
The default password is [0000].
y This unit might ask you to enter a
password when you change the
password.
y If you reset this unit, your password is
simultaneously changed to the default
setting.
1. Select and set Security d Change
Password d Next Screen.
Use / to select, then press ENTER.
Use the number buttons (0 to 9) to input the
2. Input the password.
number, then press ENTER to set.
Use / to move the cursor.
3. Re-input the password. Use the number buttons (0 to 9) to input the
number, then press ENTER to set.
Use / to move the cursor.
y To change the password, input the
previously registered password, then
input the new password.
Note
y We recommend making a note of the password.
y If you have forgotten the password, reset
the player to the factory default setting, then
register the password again (page 66).
8
 Changing the Parental Lock level for
viewing DVDs/BD-ROMs
Some DVD-Video discs containing scenes
of violence, for example, have Parental Lock
levels (check the indications on the disc's
jacket or elsewhere). To restrict viewing
these discs, set the player's level to the level
lower than the discs.
1. Select and set Security d Parental
Control d Next Screen.
Use / to select, then press ENTER.
2. Input the password. Use the number buttons (0 to 9) to input the
number, then press ENTER to set.
Use / to move the cursor.
Use / to change, then press ENTER to
3. Change the level.
set.
Note
y The level can be set to Off or between Level1
and Level8. When set to Off, viewing is not
restricted.
 Changing the Country/Area code
1. Select and set Security d Country
Code d Next Screen.
Use / tto select, then press ENTER.
Use the number buttons (0 to 9) to input the
2. Input the password.
number, then press ENTER to set.
Use / to move the cursor.
3. Change the country/area code. Use / to change, then press ENTER to
set. Refer to page 67.