The Lower Receiver; Selector Switch; The Trigger Assembly - Tippmann X7 Phenom Manual Del Usuario

The Lower Receiver

To disassemble the Lower Receiver, follow the Phenom Disassembly instructions on pages
18-19 until you have separated the Lower Receiver from the Upper Receiver.
1. Open the
Battery Door
2. Rotate

Selector Switch

Selector arm is vertical (pointing up) as shown in the diagram on page 26. Pull the
Selector Switch out from the Lower Receiver assembly.
3. Remove the
Trigger Assembly
up out of the Lower Receiver.
4. Remove the
ASA
wrench. Pull the
O-rings on the end of the
5. Remove the four
exposes the entire Gas Line assembly (13) and the
Inspect for damage. Clean if necessary. Replace if necessary.
Reassemble the Lower Receiver
1. Make sure the
(4) are in place in the
Electronics
2. Apply Tippmann grease to all O-rings on the
the
Right Lower Receiver
3. Position the Right Lower Receiver half over the Left Lower Receiver half and put them
together so that they come completely together.
4. When completely together, flip both halves over and secure the Lower Receiver halves
together with four
5. Insert the
Trigger
Selector Switch
side of the Lower Receiver. Rotate the Selector Switch to the Safe mode position.
6. Attach the
ASA
ASA up onto the Gas Line. Insert the ASA bolts (11 and 12) and tighten.
7. Reinstall the
9V Battery
To assemble the Lower Receiver to the Upper Receiver, see re-assembly instructions on
page 19:

The Trigger Assembly

1. Lay Assembly (item 3, also see framed inset diagram) flat on workbench.
Trigger
2. Pull the
Left Trigger Plate
to remove the three pins (4) from the Right Trigger plate. Replace only if necessary.
3. Inspect remaining parts for damage; replace parts only if necessary.
4. The trigger
Set Screw
adjusted. Adjusting this set screw permanently bends the
5. When finished, reinstall Left Trigger Plate back onto the Right Trigger Plate.
(7) and remove the
(5) from the Safe position, counterclockwise until the
(3) from the Lower Receiver assembly. It lifts straight
(
Air Supply Adapter) Screws
(8) straight down to remove, taking extra care to not damage the
ASA
Gas Line
(9) holding the two Lower Receiver halves together. This
Screws
(6),
Trigger Guard
half (1).
(9). Do not over-tighten as this will strip the threads.
Screws
assembly (3) into the Lower Receiver assembly. Reinstall the
(5), aligning the tab straight up, and then inserting it into the left
(8). Align the ASA to the end of the Gas Line (13). Lightly push the
(14) and the
(3) from the
(#3 in Trigger detail) is factory pre-set and should not be
9V Battery
(11 and 12) using 1/8 allen
(13).
Hall Effect Electronics
(10), and the
ASA Nuts
Left Lower Receiver
(13). Install the Gas Line into
Gas Line
(7).
Battery Door
Right Trigger Plate
27
(14).
Hall Effect
side (2).
(2). There is no need
(1).
Trigger
E
N
G
L
I
S
H
(4).