The Lower Receiver; The Trigger Assembly - Tippmann X7 PHENOM Manual Del Usuario

E
N

The Lower Receiver

G
To disassemble the Lower Receiver (refer to Figure 16), follow the Upper Receiver
L
disassembly instructions until you have separated the Lower Receiver from the Upper
I Receiver.
S
1. If applicable, open the
H
2. Rotate
Selector Switch
Selector arm is vertical (pointing up). Pull the Selector Switch out from the side of the
Lower Receiver assembly.
3. Remove the Trigger Assembly from the Lower Receiver assembly. It lifts straight up out
of the Lower Receiver.
4. Remove the
wrench. Pull the
the O-rings on the end of the
5. Remove the four
exposes the entire Gas Line (40) and (if applicable) the
the routing of the battery wires. Inspect for damage. Clean if necessary. Replace if
necessary.
Reassemble the Lower Receiver
1. Make sure the
Electronics
battery wires are routed as shown in the lower left diagram in Figure 16.
2. Apply Tippmann grease to all O-rings (91) on the
into the
Right Lower Receiver
3. Position the Right Lower Receiver half over the Left Lower Receiver half and put them
together so that they come completely together.
4. When completely together, flip both halves over and secure the Lower Receiver halves
together with four
5. Insert the
Trigger
(32), aligning the tab straight up, and then inserting it into the left side of the
Switch
Lower Receiver. Rotate the Selector Switch to Safe mode.
6. Attach the
ASA up onto the Gas Line. Insert the ASA bolts (38 and 39) and tighten.
7. If applicable, reinstall the
To assemble the Lower Receiver to the Upper Receiver, see Upper Receiver reassembly
instructions on page 20:
The Trigger Assembly (refer to the upper left diagram in Figure 16)
1. Lay
Trigger
2. Pull the
Left Trigger Plate
to remove the three pins (44) from the Right Trigger plate. Replace only if necessary.
3. Inspect remaining parts for damage; replace parts only if necessary.
4. The trigger Set Screw is factory pre-set and should not be adjusted. Adjusting this set
screw permanently bends the
replacing the Trigger assembly.
5. When finished, reinstall Left Trigger Plate back onto the Right Trigger Plate.
Battery Door
(32) counterclockwise from the Safe mode position, until the
ASA (Air Supply Adapter) Screws
(35) straight down to remove, taking extra care to not damage
ASA
Gas Line
(36) holding the two Lower Receiver halves together. This
Screws
(33),
Trigger Guard
(31) are in place in the
(36). Do not over-tighten as this will strip the threads.
Screws
assembly into the Lower Receiver assembly. Reinstall the
(35). Align the ASA to the end of the Gas Line (40). Lightly push the
ASA
9V Battery
Assembly flat on workbench.
(43) from the
Trigger
(34) and remove the
(38 and 39) using 1/8" Allen
(40).
(37), and (if applicable) the
ASA Nuts
Left Lower Receiver
Gas Line
half (29).
(91) and the
Battery Door
Right Trigger Plate
(41). Over-adjusting cannot be corrected without
22
(90).
9V Battery
(31). Note
Electronics
side (30). Make sure the
(40). Install the Gas Line
(34).
(42). There is no need
Selector