Nice Way WM080G Instrucciones Y Advertencias Para La Instalación Y El Uso página 9

text "PROG" then release the key
immediately.
02. Now use the keys – / +, to select the
NUMBER to assign to the Group, as
entered in the table.
Our example: NUMBER 03
–– Press OK to confirm the selection: the
automation Number is then shown on
the right of the display.
AUTOMATIONS
Large gate
Pedestrian gate
Terrace awning
Garage door
Kitchen shutter
Living room shutter
etc... etc...
EN
During creation of a Group, the transmitter shows two numbers, one on the right
and one on the left of the display. These numbers mean the following:
The number on the left of the dis-
play indicates GROUP.
- There is a total of 70 numbers
available.
- When the number flashes: this
means that the Group is disabled
(does not contain any automa-
tions).
- When the number remains lit:
this means that the Group is acti-
ve (contains automations).
18
03. Then use keys – / + to select the Num-
ber of the first automation to be inclu-
ded in this Group.
Our example: Number 05
–– Press OK to confirm the selection: the
number stops flashing once it has
been entered in the Group.
04. Then use keys – / + to select the Num-
ber of the second automation to be
GROUPS
N° 01 02 03
01
02
03
04
05
06
.... ....
...Overview of transmitter display
The number on the right of the dis-
play indicates the AUTOMATION
to be included (or not) in the active
Group, on the left of the display.
- There is a total of 80 numbers
available.
- When the number flashes: this
means that the automation is not
entered in the Group displayed on
the left.
- When the number remains lit:
this means that the automation is
entered in the Group displayed on
the left.
04 .... .... .... .. . ...
8
included in this Group.
Our example: Number 06
–– Press OK to confirm the selection: the
number stops flashing once it has
been entered in the Group.
Note: If the , symbol appears, refer
to the next paragraph AUTOMATIONS
CONNECTED TO A BRIGHTNESS
SENSOR.
At this point the creation of Group 03, in
our example is complete.
To proceed with the creation of another
Group, before the transmitter switches
off, press key ■ (2) and repeat the above
procedure, starting from point 02.
It is possible to exit this procedure at the
end of all operations or at any other time
by simply waiting for the transmitter to
switch off automatically.
– See summarised
➒
example in Fig.
EN
–
17