Control Reference Guide; Transmitter's Front Panel; Transmitter's Rear Panel; Headphones - Panasonic RP-WF6000 Instrucciones De Funcionamiento

Control reference guide

Transmitter's front panel

Charging terminal

Transmitter's rear panel

00 6
6
a DECODE MODE lamp ( pages 14 to 15)
(DOLBY DIGITAL, DOLBY PRO LOGIC II,
DTS, MPEG-2 AAC)
The transmitter automatically distinguishes the recording
method of the input signal and the DECODE MODE lamp
lights.
b SURROUND lamp ( page 16)
(MUSIC, CINEMA, VOICE)
c SURROUND button ( page 16)
Switch between MUSIC, CINEMA, VOICE and OFF
in SURROUND MODE.
d INPUT SELECT ( page 14)
Switch between DIGITAL 1, DIGITAL 2 and ANALOG
input.
e ID/TUNING button, lamp ( page 16)
Use when the radio waves are weak.
f OPR/CHARGE (operation/charge) lamp
( page 9)
● It glows red when the headphones are being
charged.
● It glows green when the transmitter is in operation.
● It goes out when the charging finishes or when
there are no audio signals input for approximately 5
minutes.
g ATT control ( page 13)
Switch to [0 dB] when sound from an analogue input
is low. The standard setting is [-8 dB].
h LINE IN terminal ( page 12)
To connect to the audio out terminals of AV equipment
such as a video cassette recorder or television (not
included).
i DIGITAL IN 1, 2 terminal (optical digital input)
( page 11)
To connect to digital equipment such as a DVD player
or a television (not included).
j DIGITAL OUT terminal (optical digital output)
( page 11)
The same digital signal as the input signal selected
with the INPUT SELECT control is output.
● When ANALOG is selected, the same digital signal
as the input signal to DIGITAL IN 2 is output.
INPUT
SELECT DIGITAL OUT
control
The same signal as the signal input
DIGITAL 1
to DIGITAL 1
DIGITAL 2 The same signal as the signal input
to DIGITAL 2
ANALOG
k DC IN 9V terminal ( page 8)
To connect to the supplied AC adaptor.
(Use only the supplied AC adaptor. Use of other AC
adaptors with, for example, a different plug polarity is
dangerous and can damage the unit.)

Headphones

l Ear pad (left)
m Charging terminal
n Left housing
o BATT (battery) knob (
page 8)
p Battery compartment lid
Press BATT to open the battery compartment lid.
Use the supplied rechargeable battery or "LR6, AA"
alkaline dry cell batteries (not included).
q Free-adjusting band ( page 10)
The power turns on automatically and the OPR lamp
lights when you put on the free-adjusting band.
r OPR (operation) lamp
Pull up the free-adjusting band and check that the OPR
lamp glows red. You can now use the headphones.
s Right housing
t Ear pad (right)
u ID button, VOL control
page 14
VOL: When adjusting the volume ( )
7
7