Specifications; Rs232 Communication Interface - Sartorius YDO01MS-R Instrucciones De Instalación

Specifications

RS-232 Data Interface Port
3
Warning when using pre-wired RS-232 connecting cables:
RS-232 cables purchased from other manufacturers often have incorrect pin assignments for use with Sartorius
devices.
Therefore, be sure to check the pin assignments against the chart before connecting the cable and disconnect any
lines marked differently (such as pin 6). Failure to do so may damage or totally ruin your weighing system and/or
peripheral devices.
Features
Type of interface:
Interface operating mode:
Level:
Port:
Transmission rate:
Parity:
Character transmission:
Handshake (selectable):
Parameter Factory Settings:
Transmission rate:
Parity:
Stop bits:
Handshake:
Operating mode:
Manual print:
Print automatic:
Cancel automatic printing:
Time-dependent automatic
printout:
Taring after individual print:
Line format:
Character transmission:
Serial Interface
Full duplex
RS232
25-pin D-Sub female connector
150, 300, 600, 1200, 2400, 4800, 9600 and 19200 baud (selectable)
Odd, even, none; space (selectable)
Start bit, 7/8 bit ASCII, parity, 1 or 2 stop bits (selectable)
For 2-wire interface: Software (XON/XOFF)
For 4-wire interface: Hardware (CTS/DTR)
9600 baud
Odd
1
Hardware handshake, 1 character after CTS
SBI
After stability
Without stability
Canceling not possible
After 1 display update
Off
22 characters
8 Data bits
Specifications
Installation Instructions
9