General Operation; Powering On; Operation In Normal Mode; Selecting The Type Of Wind - ADVANSEA WIND S400 Manual De Instrucciones

2 General Operation

2.1. Powering on

The WIND/WIND-a S400 display does not include an integrated switch. The unit is
powered by a 12 V DC supply on the red (+) and black (-) wires. When stopped, all
settings are memorized.

2.2. Operation in normal mode

2.2.1. Selecting the type of wind

Select the apparent or true wind data (in this case the boat speed must be received
either by the communication bus or by the NMEA input interface) by pressing
An icon "APPARENT" or "TRUE" is displayed to show the different type of wind
display.
The WIND/WIND-a display can only display the true wind if it is connected to a
speedometer or GPS.

2.2.2. Selecting information

The key is used to select various data in the lower line.
Key operation:
Wind speed Wind speed
VMG (if connected to speed source) VMG (if connected to speed source)
MAX wind speed MAX wind speed
Battery voltage Battery voltage
Installation and Operation Manual S400 series
8