Troubleshooting Guide; Disposal Information - MIRKA AROP-B 312NV Instrucciones De Manejo

Troubleshooting guide

Symptom
No light from the right LED of the
polisher when trigger is pressed.
The right polisher LED is red and the
polisher slows down to 4,000 rpm
(AROP-B 312NV) or 1,500 rpm (ARP-B
300NV) stops when polishing.
The right LED of the polisher is red and
rpm is slightly reduced.
The left LED of the polisher is red and
the polisher is not running.
The left led of the polisher is flashing
red although the battery is fully
charged.

Disposal information

DANGER: Disposal guidelines for old appliances Render redundant power tools unusable by
removing the power cord Only for EU countries Do not dispose of electric tools along with household
waste According to European Directives 2011/65/EU, 2012/19/EU + 2003/108/EC on waste electrical
and electronic equipment and its implementation under national law, electric tools that have reached
the end of their life must be collected separately and taken to an environmentally compatible
recycling facility
Possible cause
Battery pack not properly attached to the
polisher
Battery totally empty
Temperature too high in the polisher
Heavy load for too long
Too heavy short-term load
The battery voltage is too low
Battery failure Please use the App for
diagnostics
Mirka® AROP-B 312NV & ARP-B 300NV • 77 mm (3") • 10.8 V
Solution
Insert the battery properly
Charge the battery
Reduce the load on the polisher for some
time and the polisher will speed up again
Use lighter load or wait a moment and the
LED will automatically change to green
Charge the battery
Replace the battery
en
61