How To Operate The Edger - Craftsman 536.772321 Manual Del Usario

How To Operate The Edger
The edger is designed to cut a small trench along
sidewalks and driveways or to trim close to trees,
flower beds, lampposts, etc. The main reason for
edging is to enhance the overall appeal of the yard. A
cleanly-edged yard gives a nice, overall finished look.
Always dress properly to protect against flying debris.
Wear substantial shoes, long pants and close-fitting
clothes that are not likely to get caught in the
machinery. Also, make sure to wear safety glasses or
goggles.
WARNING
' Always Wear safety glasses or eye shields while
you assemble, oF
the unit.
To reduce the risk of flying debris, inspect the area
and remove any stones, sticks or other objects that
could be thrown by the edger.
If the lawn has not been edged in a while, it may take
several passes to obtain a nice, clean edge.
NOTE: References to the right or left side of the
edger are from the viewpoint of the operator's
position behind the unit.
1 Before you start the engine, move the depth
control lever (D) forward until the blade (A) will not
contact the ground.
When edging along a concrete driveway or
sidewalk, set the wheels on the concrete and
position the blade along the left side of the
driveway. To keep the blade from hitting the
driveway, make sure to keep the blade guide (B)
aligned with the side of the driveway. See
Figure 12.
3 Start the engine. See "How To Start The Engine",
4 Move the depth control lever back to lower the
blade. Do not try to edge too deep. It may take
several passes to obtain a nice clean edge.
5 Stand behind the edger and firmly hold the handle
(D). See Figure 12. As the blade begins to cut,
slowly move forward.
6 Proceed at a moderate pace until you are
comfortable with the handling of the edger.
c
D
Figure 12: Operation Of Edger
15