Starting A Blood Pressure Measurement - Welby ABO 523 Manual Del Usuario

USA
Performing a measurement

Starting a blood pressure measurement

You can always cancel blood pressure
measurements that are in progress (e.g. when
the pressure in the cuff becomes too extreme)
by pressing the START/STOP button.
1. After the blood pressure monitor is powered, press
the SET button
Do not press the START/STOP button
moment.
A user icon ( or )
2. Press the M button
user icon 2.
This allows the measurements to be saved into
the memory slots of the selected user after the
measurement is done.
3. Press the START/STOP button to save the setting.
You may skip steps 1–3 if you do not intend to
save the measurement results into memory.
4. Press the START/STOP button to start the
measurement.
5. You will hear a beep tone and then an English
instruction, saying that the measurement will now
begin.
If there is residual air in the cuff
measurement, air will be released from the cuff until
26
greaterconcepts@live.com
.
4
will show on the display
14
to select either user icon 1 or
2
USA
at this
3
from the previous
9
815-342-5850
.
1