Assuming The Correct Posture - Welby ABO 523 Manual Del Usuario

Ocultar thumbs Ver también para ABO 523:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

2. Wrap the cuff
The bottom edge of the cuff must be 0.4–0.8 inch
(1–2 cm) above the elbow and over the artery (see
step 1 in Fig. C). The cuff hose
the middle of the palm.
3. Place the free end of the cuff around the arm.
The cuff must be fitted tightly enough so that two
fingers can fit under the cuff.
4. Once the cuff has been properly fitted, close the
hook and loop fastener on the cuff.
5. Connect the air plug

Assuming the correct posture

Perform measurements while sitting or lying down and
observe the following instructions:
− The cuff must be roughly at the height of the heart,
but no higher (see step 2 in Fig. C).
− Rest the arms in a relaxed position. A chair with
armrests or a table are required for measurements
while sitting (see step 3 in Fig. C).
− Do not move and do not speak while performing a
measurement.
When sitting, observe also the following instructions:
− Sit in a relaxed position when measuring the blood
pressure and lean back.
− Place the feet flat on the ground.
− Do not cross the legs.
AFTER SALES SUPPORT
Performing a measurement
around the exposed upper arm.
9
of the cuff to the air jack
11
815-342-5850
USA
must point towards
10
USA
.
7
25

Publicidad

Capítulos

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

93630

Tabla de contenido