Vetus RWPANEL2 Manual De Uso página 7

Ocultar thumbs Ver también para RWPANEL2:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 19
Introduction
Using this windscreen wiper controller, a
maximum of 3 wipers can be synchroni-
sed at low and high speed as well as in
interval settings. The windshield wiper
controller is also equipped with an auto-
matic wipe/wash function. A maximum of
3 rain sensors can also be optionally
connected.
The windshield wiper controller consists
of a controller unit and a panel to be built
in. The controller unit is suitable for both
12 and 24 volts. Each output can have a
maximum load of 120 W and is protected
against overloading.
The windshield wiper motors to be used
must have 1 or 2 wipe speeds and an
automatic park setting.
RWPANEL2 is delivered with:
1 x Panel
1 x Controller unit
2 x Cable spade
1 x DIN Rail TS35
1 x Manual
1x 10-pole connector
Operation
Wiper button
The three wiper switches on the
panel can be used to operate three
wipers in
total.
Each wiper (windshield wi-
per motor) has its own switch.The switch
is used to turn the relevant wiper on or off.
When a wiper is switched on, it follows the
selected programme.
Windscreen wiper controller
SPEED button
If the rain sensor has not been acti-
vated, the SPEED switch can be
used to select the interval system.
Whenever the SPEED switch is pressed,
the next wipe programme is selected.
The available programmes are:
1 interval 11 sec,
2 interval 9 sec,
3 interval 7 sec,
4 interval 5 sec,
5 interval 3 sec,
6 continuous low speed,
7 continuous high speed.
Once programme 7 is reached, pressing
the switch selects programme 1 again.
After a different programme is selected,
the status lamp indicates the new setting
by means of a series of flashes (1 to 7);
this series is repeated twice. See p. 27
'Using the SPEED button'.
On first use and each time after the cur-
rent is switched off, the windshield wipers
will wipe at low speed.
If the current has not been switched off,
the wipers will wipe at the last interval
setting or speed selected, unless the last
setting was the highest speed.
The wiper motors can be operated auto-
matically if rain sensors have been instal-
led; consult the manual supplied with the
rain sensors.
ENGLISH
7
101005.01

Publicidad

Tabla de contenido
loading

Tabla de contenido