MIRKA DEROS 650CV Instrucciones De Manejo página 5

WARNING
• Always wear required personal safety protection in accordance with manufacturer's instruction and
local/national standards while using this tool.
• Do not use a power tool while you are tired or under the influence of drugs, alcohol or medication.
• Read the Materials Safety Data Sheet (MSDS) for the working surface.
• Use the tool with dust extraction. Suited dust extraction unit will reduce hazardous dust.
• Do not overreach. The operator must ensure to have a secure position with a firm grip and footing on
solid floor.
• Do not wear loose clothing or jewellery. Keep your hair, clothing and gloves away from moving parts.
Loose clothes, jewellery or long hair can be caught in moving parts.
• If any physical hand/wrist discomfort is experienced, Stop working and seek medical attention. Hand,
wrist and arm injury may result from repetitive work, motion and overexposure to vibrations.
• Do not operate power tools in explosive atmospheres, such as in the presence of flammable liquids,
gases or dust. Power tools create sparks which may ignite the dust or fumes.
CAUTION
• Remove pad wrench before connecting the tool to the power source.
• Keep work area clean and well lit.
• Always ensure that the work piece to be sanded is firmly fixed.
• Before changing abrasive always disconnect the power source. Be careful to properly attach and center
the abrasive to the backing pad.
• Keep children and bystanders away while operating a power tool. Distractions can cause you to lose control.
• Always care for work safety, never carry, store or leave the tool unattended with the power source connected.
• Keep hands clear of the spinning pad during use.
• Do not allow the tool to free speed without taking precautions to protect any persons or objects from
the loss of the abrasive or pad.
ADDITIONAL SAFETY WARNINGS
• Read all instructions before using this tool. All operators must be fully trained in usage and safety of this tool.
• All maintenance must be carried out by trained personnel. For service, contact Mirka authorized service center!
• Power supply socket and connector are non-IEC appliance couplers. Only MIRKA original power supply
cable should be used. The MIRKA power supply cable can be bought from your Mirka Dealer; (Code:
8292605011), UK (Code: 8292502511).
• Check tool, backing pad, power cord and fittings regularly for wear.
• Vacuum unit dust collection bag should be cleaned or replaced daily. Dust can be highly combustible.
Cleaning or replacing of bag also assures optimum performance.
• Always ensure that the power tool specifications correspond to the power source (Volt, Hz).
• Take care to avoid entanglement with the moving parts of the tool with clothing, ties, hair, cleaning rags, etc.
• If the tool appears to malfunction, remove from use immediately and arrange for service and repair.
5