Mobile App And Wi-Fi Connection - cecotec Conga 7090 Manual De Instrucciones

ENGLISH
Warnings:
Remove the Wet & dry tank from the robot before charging it.
Make sure there are no obstacles in the room being cleaned to ensure the robot can get to the
charging base without problems.
Functions
Pause
While the robot is operating, press the power button on the App, the remote control or on the
robot to pause it and press the same button again to resume cleaning.
Standby
The robot will automatically enter standby mode after 5 minutes of no operation.
Press the power button on the App, the remote control or on the robot to start it up again.
Warnings:
After 12 hours of no operation, the robot will turn automatically off.
The robot will not enter standby mode during charging.
Suction power level
Press the power levels button on the remote control to select the desired power level.
Choose between Eco (low power), Medium (medium power) and Turbo (high power).
Schedule
Warning: The robot cannot be scheduled from more than one device at a time. Make sure to
schedule it either from the mobile phone App or from the remote control.
The robot is provided with a schedule function in order to provide a maximum-efficiency
cleaning. The time settings and the cleaning scheduling must be carried out from the remote
control. Once the robot has been scheduled, it will automatically carry out the cleaning cycles
every scheduled day.
Note: Make sure the robot is activated and that the light indicator is lighted before scheduling
any cleaning or setting time.
Current time
Fig. 20.
Hold down the time button for 3 seconds. The first 2 digits, indicating the hour, will start
blinking.
Use the up and down direction buttons to set the current time. Then, use the left and right
buttons to switch from hours to minutes and repeat the before step.
Fig. 21.
Press the time button again to save the settings.
42
7090
Scheduling cleaning tasks
Long press the schedule button for 3 seconds. The first 2 digits, indicating the hour, will start
blinking.
Fig. 22.
Use the up and down direction buttons to set the schedule time. Then, use the left and right
buttons to switch from hours to minutes and repeat the before step.
Fig. 23.
Press the schedule button again to save the settings.
To cancel the scheduled cleaning, follow the below steps:
Set the clock on the remote control at 00:00 a.m. and save it.
Switch the robot off for 1 minute and switch it on again.
Note: The robot will beep to indicate all settings have been saved.
Warning: When the remote control's batteries are replaced, the clock and schedule times
must be set again.
ARTIFICIAL INTELLIGENCE
All modes operate with artificial intelligence in order to optimise the cleaning cycles through
obstacle detection and type of floor recognition. Make sure that the area to be cleaned is
properly illuminated. This way, the robot is able to recognise small objects such as socks,
cables, fan support feet or even pets. This allows the robot to plan cleaning routes avoiding
obstacles. It detects and recognises the type of floor in each room and suggests cleaning
tips on the type of brush to be used or scrubbing level to be selected for that specific room
according to the type of floor. This information will be displayed on the App as long as the
robot is linked.
Light indicator:
Operating: Steady blue light
Low battery: Orange light blinks slowly.
Charging: Orange light oscillates.
Network configuration: Blue light.
Start-up/firmware update: Blue light oscillates.
Error: Red light flashes quickly.

5. MOBILE APP AND WI-FI CONNECTION

In order to access all the robot's functions from wherever you are, it is suggested to
download the Conga 7090 App. You will be able to control the robot in the most efficient way,
enjoying the excellence of cleaning.
ENGLISH
43
7090