Assembling The Support Rod; Process - IKA C-MAG HS 7 control Manual De Instrucciones

Ocultar thumbs Ver también para C-MAG HS 7 control:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Assembling the support rod

/// Process

Note! (
)
Review the mounting and safety instructions of the IKA boss head clamp
prior to using it. (see "Accessories")
The device must not be suspended from the support rod!
Procedure
Remove the threaded plug in the threaded hole (O).
1.
Remove the protective cap from the support rod.
2.
Place the washer between the housing and the nut.
3.
Screw in the support rod manually until it no longer can be tightened.
4.
Tighten the nut using an SW17 open-end spanner.
5.
Assemble the accessories using a boss head clamp.
6.
20
Assembling the support rod
Note! (
)
When using bath attachments with a diameter over 180 mm, use support
rod in conjunction with an extension. (see "Accessories")
Risk of tipping! (
)
Make sure that the center of mass of the attached device does not protrude
over the safe area indicated below with a dotted rectangle.
safe area
Assembling the support rod
21

Hide quick links:

Publicidad

Tabla de contenido
loading

Tabla de contenido