Clatronic HMS 2477 Instrucciones De Servicio página 23

33639-05-HMS 2477
This is for switching to maximum speed for a short time. Press at short intervals for
pulsed mode operation.
WARNING! Do not use this function for more than one minute!
1. Position the speed regulator on 0/AUS (3) and make sure that the mixer (1) is
not connected to the mains.
2. Remove the mounting slot cover by pulling it upwards.
3. Mount the beater (9).
4. Insert the plug into a 230V/50Hz socket.
5. Insert the beater into a high and partly filled bowl.
6. Activate Turbo-speed by pushing forward the speed regulator (3). Move the bea-
ter around gently.
How to use the Kneader hooks/beater
1. Position the speed regulator on 0/AUS (3) and make sure that the mixer (1) is
not connected to the mains.
2. Press the end of the kneader hooks/beater (10) into the corresponding mixer
openings until the hooks click into place. While pressing, turn slightly in order to
facilitate the whole operation.
3. Insert the plug into a 230V/50Hz socket.
4. The handmixer (1) can be used at various speeds set with the speed regulator
(3).
5. When removing the kneader hooks/beater (10), position the speed regulator on
0/AUS and make sure that the mixer is not connected to the mains.
6. Press the orange button (2) to release the kneader hooks/beater. Remove the
device by turning it slightly.
1. Remove the mounting slot cover by pulling it upwards.
2. Then place the handmixer on the upper part (5) of the mixer stand (4) and push
it back until the slot on the lower part of the mixer is locked onto the pin of the
upper part (5) of the mixer stand.
3. Mount the hooks as described above in the section "How to use the Kneader
hooks/beater".
4. In order to place the mixer bowl (8) below the mixer, press the button for the
release of the upper part of the mixer stand (5) and lift the mixer.
5. Place the mixer bowl filled with the desired ingredients onto the revolving plate
(7). Press the button for the release of the upper part of the mixer stand (5) and
lower the mixer.
6. Insert the plug into a 230V/50Hz socket.
03.06.2004
Turbo operation
How to use the Beater
How to use the Mixer stand
12:24 Uhr Seite 23
GB
23