Accessories - Friedrich VERT-I-PAK A Serie Manual De Instrucciones

Accessories

M O D L E
VPAWP1-8
VPAWP1-14
VPAL2
VPSC2
RT4
RT5
RT6
VPRG4
VPDP1
20
D
WALL PLENUM Two-part sleeve that telescopes in and out
1
from 5 to 8 in depth. The wall plenum sits inside the
2
exterior wall penetration.
3
DIMENSIONS: 30 high x 24
8
CUTOUT DIMENSIONS: 30
Same as VPAWP1-8, but telescopes 8 to 14 as required.
ARCHITECTURAL LOUVER Extruded aluminum louver
that attaches to the outdoor section of the wall plenum.
DIMENSIONS: 31 1 high x 25
16
Same as VPAL2 but can be ordered in a special color to
match the exterior wall.
DIGITAL REMOTE WALL THERMOSTAT Single stage
thermostat, used on VERT-I-PAK units. Hard wired with
single speed fan. Direct replacement for RT2.
DIGITAL REMOTE WALL THERMOSTAT Single stage
thermostat. Features high/low fan speed switch. Thermostat
is hard wired and can be battery powered or unit powered.
Features backlit display and multiple configured modes.
DIGITAL REMOTE WALL THERMOSTAT
cool, single stage heat thermostat. Features high/low fan
speed switch. Thermostat is hard wired and can be battery
powered or unit powered. Features backlight display and
multiple configuration.
ACCESS PANEL / RETURN AIR GRILLE - Serves as an
access panel to chassis and interior return air grille. A
field-supplied (25" x 20") filter is mounted inside the hinged
access door.
Kit contains hinge bracket for mounting the door with the return
air openings high or low on the door for optimal sound
attenuation.
For 9,000 / 12,000 / 18,000 Btu models, it is recommended to
install the door with the hinge on the right side and the return air
openings high on the door. For 24,000 Btu models, it is
recommended to install the hinge on the left side with the return
air openings low on the door.
DIMENSIONS: 58" high x 29" wide.
CUTOUT DIMENSIONS: 55
DRAIN PAN Drain pan may be installed prior to chassis for
easy installation/removal.
E S C I R T P O I N
1 wide
8
7 5
high x 24 wide.
8 8
9 wide.
16
Single stage
3 " high x 27" wide.
/
4
P H O T O