Functions; Operation - Amann Girrbach therm 3 Modo De Empleo

A P P L I C A T I O N A N D O P E R A T I O N
6.3

Functions

Handling
E N
▷ To select a function: Press the
respective number key.
▪ Key 4: Function "Preset time for program"
Programming
To program function 4:
▷ Press the
▷ Press the
▷ Using the number keys, enter the desired time
[hh:mm] until the program starts. The time is
rounded exactly to 10 minutes.
After entering the last digit, the cursor will
jump back to the first numerical location,
so that possibly required corrections can
still be made.
▷ Press the
▷ Press the
▷ In the list, select the desired program with the
keys
-or-
▷ directly select the program by pressing the
key and the respective number key.
▷ Press the
The program is taken over with the time preset.
The display switches to the operating level.
After the program starts, the preset time runs
off first, then the program starts.
32
key and the
key.
key.
key.
key.
key.
6.4

Operation

NOTE:
Damage to the heating rods!
▷ When loading and unloading the furnace, do
not bump against or come in contact with the
heating rods!
▷ When sintering zirconium frames, use a sinter-
ing bowl filled with sintering pearls.
▷ Using the sintering bowl tongs, carefully place
the sintering bowl into the furnace (up to 3
bowls are stackable).
The placement of zirconium frames in the sinter-
ing bowl is described in the instructions of the zir-
conium-oxide blanks.
▷ Load the furnace with the units.
▷ Shut the furnace door.
▷ Switch the furnace on with the mains switch.
▷ Select the sintering program (see page 30).
▷ Define the sintering program, if required (see
page 31).
▷ Start the sintering program with the
After the program has elapsed, the heating
cycle automatically switches off.
WARNING:
Danger of burning!
▷ To remove the sintering bowl, use the sinter-
ing-bowl prongs or other suitable pliers.
key.