General Operation - Clatronic CDP 604 MP3/VCD Instrucciones De Servicio

Ocultar thumbs

Contenido

100

101

página de 101

/ 101
Contenido
Tabla de contenido
Marcadores

Tabla de contenido

Idiomas disponibles

5....-05-CDP 604 neu

Batteries in the Remote Control

The battery in the remote control is a long-life lithium cell. If the range of the remote

control decreases, please proceed as follows:

•

Open the battery compartment on the side of the remote control.

•

Replace the cell with a battery of the same type. Ensure the correct polarity.

•

Close the battery compartment.

Mains Operation

It is possible to operate the device using the mains power unit.

1. Insert the plug of the power unit into a correctly installed 230V, 50 Hz wall

socket.

2. Connect the CD player to the power unit by inserting the plug of the power unit

into the DC 4.5 V socket (12).

3. When using a power unit (DC 4.5V/700mA) ensure the correct polarity accor-

ding to the inscriptions on the CD player.

Car Operating Mode

Thanks to the adapter cassette and the cigarette lighter adapter the CD player can

be used on your car radio with the cassette adapter.

1. Insert the cigarette lighter adapter in the cigarette lighter and the jack at the end

of the cable into the 4.5V/DC socket of the CD player.

2. Insert the jack of the adapter cassette into the AV OUT socket of the CD player.

3. Switch on your car radio and insert the adapter cassette into the cassette deck.

Make sure that the connector cable of the adapter cassette is inserted correctly

into the cassette slot! The cassette mechanism may jam!

Some car radios may eject the adapter cassette immediately after inserting it. In

this case fit the cassette's connector cable along the slot and insert the cassette

turned over on the other side. If the car radio ejects the adapter cassette again, the

adapter cassette cannot be used.

AUDIO/

EQ (6):

HOLD (9):

15.06.2004