Operation; Operation Instructions; Start Electrical Support; Machine Stopping / Parking - Zipper Maschinen ZI-EWB500LI Instrucciones De Servicio

13

OPERATION

Device to be operated in a perfect state only. Inspect the device visually every time it is to be
used. Check in particular the safety equipment, electrical controls, electric cables and screwed
connection for damage and if tightened properly. Replace any damaged parts before operating the
device.
13.1

Operation instructions

 Never remove the battery while the machine is running
 In case of longer standstill, press the shut-down button
 Use the electric motor only with sufficient battery charge
13.2 Operation

13.2.1 Start electrical support

13.2.2 Machine stopping / parking

ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-EWB500LI-AKKU
WARNING
Unplug battery before all maintenance and settings!
1. Turn swith to Position „I"
2. Turn switch (1) on the handle to "0" BAS activated /EBS
deactivated.
BAS = Brake assistance if no electronic support is
requested
EBS = Electronic Brake: Machine is braked and braking
effect is maintained as long as
- until battery empty
- until EBS is deactivated again
3. Turn the right-hand control handle (2) to adjust the
strength of the electrical support, the further the handle is
turned counterclockwise (+) the stronger the support.
Note: no activation on electrical support means BAS active
(braking effect noticeable)
1. Turn power swith to Position „I"
2. Switch (1) on the handle set to "0" BAS activated.
The machine must be braked by manually by manpower
when used on slopes.
3. switch (1) on the handle set to "I" EBS activated
The machine brakes until it comes to a complete stand still
and the braking effect remains active as long as the switch
is set to position "I". Also holds the machine in position on
slops up to 20%. If the machine is left standing for a
NOTICE
OPERATION
23