Troubleshooting - EGO Power+ SNT2100 Manual Del Operador

Ocultar thumbs Ver también para Power+ SNT2100:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

TROUBLESHOOTING

WARNING:
the snow blower. Always protect your hands by wearing gloves when performing any
maintenance on the snow blower auger or scraper.
PROBLEM
Side rails are not in
position.
Snow blower is not starting.
The motor is on but the
auger does not turn.
After passing, the snow
blower leaves a layer of
snow on the ground.
ACCESSORIES
WARNING:
Use only identical replacement parts listed below. Use of parts that do not meet the
original equipment specifications may lead to improper performance and compromised
safety.
PART NAME
Scraper Bar
Rubber Paddle
Drive Belt
Always remove the battery pack(s) when servicing or transporting
CAUSE
Knobs on the side rails
and/or handle-clamp
lever are not secured.
Battery charge is low.
Safety button is not
depressed.
The drive belt is worn
or broken.
The scraper bar is
worn.
The following parts are subjected to be worn out from normal use.
56V LITHIUM-ION CORDLESS SNOW BLOWER — SNT2100
SOLUTION
Make sure that knobs on the side
rails are fully tightened and the
handle-clamp levers are fully
closed.
Charge the battery.
Press the safety button and then
squeeze the bail switch.
Replace the drive belt following
the section "REPLACING THE
DRIVE BELT" in this manual.
Replace the scraper following
the section "REPLACING THE
SCRAPER BAR" in this manual.
MODEL NUMBER
ASS2100
ARP2100
AVB2306
31

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido