Replacing The Drive Belt - EGO Power+ SNT2100 Manual Del Operador

REPLACING THE RUBBER PADDLE
WARNING:
off the bail switch and remove the
battery pack(s) before performing any
maintenance task on your snow blower.
NOTICE:
When replacing worn rubber
paddles, pay close attention to the order
in which you remove them. Assemble the
new rubber paddles in the reverse order
of the disassembly.
1. Use two 10mm wrenches (not
included) to remove the 8 sets of
nuts and bolts fixed on the middle
steel plates and the 4 sets of nuts,
washers and bolts on each side (total
of 8 sets), that are used to secure the
rubber paddles (Fig. 26 & 27).
2. Remove the paddles.
3. Install the new rubber paddles in the
reverse order of the disassembly.
Secure them by tightening the 4
sets of nuts, washers and bolts on
each side (total of 8 sets) and the 8
sets of nuts and bolts in the middle.

REPLACING THE DRIVE BELT

If the drive belt becomes worn, oil-soaked, excessively cracked, frayed, or otherwise
damaged, replace the belt.
WARNING:
before performing any maintenance task on your snow blower.
1. Use a T20 Torx screwdriver (not included) to remove the drive belt cover by
removing the 8 Torx screws as shown in Fig. 28.
28
56V LITHIUM-ION CORDLESS SNOW BLOWER — SNT2100
Make sure to turn
Make sure to turn off the bail switch and remove the battery pack(s)
26 8 sets of bolts
and nuts
4 sets of bolts, washers and nuts on
each side (total of 8 sets)
27
28
Torx screw
Drive Belt
Cover
Steel Plates