Sinmag Europe SPIRALO XL 120A Manual De Instrucciones página 20

5. TRANSPORTATION
REMARK:
ENG
operation and components of machine.
Check encasement to see if there is any damage before unpacking the case.
A.
After unpacking the top and sides of wooden case, use strong nylon rope to tie to the
B.
four rings. Then lift the machine from the bottom wooden board and move it to the
installation position.
Pay attention that the head will not tilt and fall down to prevent oil leakage. The
machine should be placed slowly and steadily.
6. INSTALLATION
Install the machine on a horizontal and plain floor to maintain its appearance and make its
1.
wiring in a good condition for long.
2. Make sure that the bottom plate of the machine is parallel with the floor, if not, you can
adjust it by adjusting leveling screws. (remark: floor must be flat the 6 seats (broken line
position) must touchdown at one time.
After adjusting it, put plate washers to support the bottom plate of the machine.
3.
Take out the leveling screws. At this position, fix the machine firmly to the ground by 5/8"
4.
upset bolt.
Connect the electric power cables to the machine with a circuit breaker which is about
5.
2m high above ground level.
After electric connection, check the rotation of the bowl and the hook. Both of them
6.
should rotate clockwise when looking overhead. If wrong, exchange two power cables
and test again until it is right.
Push "UP" button. The head of the machine will move up to the top position and stop
7.
automatically.
In this position, we can test degree of tightness of bowl position guide rod. Pull the trolley
8.
20
SM120A and SM200A share the same transportation, installation