Instructions For Maintenance - IRUDEK LIGHT PLUS 1 Instrucciones De Uso

INSTRUCTIONS FOR MAINTENANCE

-CLEANING: The personal protective equipment must be
cleaned without causing adverse
effect on the materials used in the manufacture of the
equipment. For textile (webbing and ropes) and plastic
parts wipe with cotton cloth or a soft brush. Do not use any
abrasive material. For intensive cleaning wash the harness
at a temperature between 30ºC and 60ºC using a neutral
detergent. For metallic parts wipe with a wet cloth. When the
equipment becomes wet, either from being in use or when
due to cleaning, it shall be allowed to dry naturally, and shall
be kept away from direct heat.
-STORAGE: Personal protective equipment should be stored
loosely packed, in a dry and well
- ventilated place, protected from direct light, UV degradation,
dust, sharp edges, extreme temperature and aggressive
substances.
REPAIR
Any repair shall only be carried out by equipment manufacturer
or his authorized representative following manufacturer's
procedures.
MARKING
The equipment is marked with the next information:
i)CE marking, Conformity to European Legislation
ii) Identification of the manufacturer
iii) Reference of the equipment
iv) Lot or serial number
v) Year of manufacture
vi) Material