Installing batteries (Battery size : AA)
2
1. Press the back of the remote at the very bottom with both thumbs, and then slide the battery cover up
in the direction of the arrow.
2. Install two batteries so that the polarity of the batteries (+/-) matches the illustration in the battery
compartment.
3. Slide the cover down in the direction of the arrow to close the battery cover.
Initial Pairing for Smart Touch Control
After you have run the Initial Setup on your TV, you should connect your Smart Touch Control to your TV.
1. Point the Smart Touch remote control toward the TV's IR Blaster and press any key on the Smart
Touch remote control.
2. The connection icon appears at the bottom left of the screen and the Smart Touch remote control is
automatically connected to the TV.
If you want to perform the pairing process again, press the reset button in the center of the back
✎
cover using a pin or the tip of an unbent paper clip. The Smart Touch Control will be initialized.
Calibrating the Touch Pad
To calibrate the touch pad on the Smart Touch Control, follow these steps:
1. Press the
NUMBERš
2. When done, all the LEDs on the top of the Smart Touch Control blink twice simultaneously.
While calibrating, don't touch the touch pad.
✎
If the touch pad looses accuracy, re-calibrate the touch pad by repeating Steps 1 and 2.
✎
1 1
• Smart Touch Control
button for 3 seconds. The calibration starts.
English - 40
PAIRING
Reset button.