When you connect an IR Blaster with your TV, you can control connected external devices with your TV
using the Smart Touch Control.
Install the IR Blaster within 50 cm and 45 degrees of the up, down, left and right directions of the IR
✎
sensor of the external device.
IR Blaster
Power Switch
Installing batteries (Battery size : AA)
1
2
1
1. Hold the both sides of the battery holder and pull it out.
2. Install four batteries so that the polarity of the batteries (+/-) matches the illustration in the battery
compartment.
3. Push it back.
The IR Blaster
Pairing Button
OPEN
PAIRING
1
ON
2
OFF
1
English - 43
Device Indicator LED
IR Blaster shows the pairing state.