Safety Instructions; Installation - PC Locs LocknCharge FUYL Tower Instrucciones Para El Usuario

FUYL Tower™

SAFETY INSTRUCTIONS

For your safety – Do not operate the unit if the plug, power socket or power cable is damaged.
To reduce the risk of fire, electrical shock and/or injury, the following basic precautions should be followed:
• This device is not intended for use by persons (including children) with reduced physical, sensory and
mental capabilities, or lack of experience and knowledge, unless they have been given supervision or
instructions concerning the use of the device by a person responsible for their safety.
• CAUTION: To reduce the Risk of Electric Shock – use only indoors.
• Keep away from all sources of water or moisture. Never expose the devices to the rain or dangerous
gas.
• Parts of the unit, including devices charging within the unit, may be warm during operation. Install
the unit in a dry and cool place and do not cover ventilation holes. Ensure sufficient ventilation at all
times.
• Do not overload the socket-outlets.
• Before using the product, check and make sure all devices are correctly and properly connected.
• Arrange the power cord away from traffic areas where it will not be tripped over.
• The unit is powered when the main supply is connected and switched on.
• Do not try to repair, disassemble or modify the unit. There are no user-serviceable parts inside.
• Do not use the product other than for its intended use.

INSTALLATION

1. CAUTION: The FUYL Tower weighs 78Kg or 172Lbs. Take appropriate lifting precautions while moving.
2. Lay the delivery carton horizontal, unpack the carton and free the FUYL Tower from the packaging.
3. Using the keys attached to the base of the cabinet unlock and open the large access door and remove
the parts box and any packaging that is present.
4. Locate the 4 adjustable feet and screw them into the corner brackets at the base of the cabinet.
5. Manoeuvre the FUYL Tower into an upright position by raising it out of the carton. Use lifting
apparatus if necessary for safe lifting. Please discard the packaging with thought for the environment.
6. When choosing a location for the FUYL Tower, consider the following:
a) The LCD display will be more readable when ambient light levels are lower.
b) Direct sunlight should be avoided in hot climates, as temperatures within the unit could exceed
operating temperatures of stored devices.
c) Choosing public, well trafficked areas will contribute to the safety of users and reduce the likelihood
of successful break-in.
d) The main power lead for the FUYL Tower should be connected in a location that is concealed, to
avoid accidental or deliberate power down of the unit while devices are charging.
e) If network connectivity is needed, a coiled section of network cable is provided in the undershelf of
the unit. If necessary, this can be extended using a commonly available Ethernet adaptor.
7. The locker cabinet will require either a dual mains socket or a permanent electrical junction box,
preferably directly behind or above the cabinet. Any necessary electrical installation should be done
by suitably qualified installers before the cabinet is moved into place.
8. If network connectivity will be required then a LAN port or cable must be provided in an appropriate
location close to the cabinet.
9. The mains supply cables should be fitted to the cabinet before it is moved into the final position. Plug
each cable into the appropriate distribution board, feed the cables through the access point in the
rear of the cabinet and fix both in place using the supplied P-clamps and any other method that may
be required according to local regulations.
10. Position the FUYL Tower into installation location, 40-90mm from the wall, and level/stabilise the
cabinet by adjusting the feet at the base. Fix to the wall using the supplied mounting bracket on top of
the unit. Fixing to the wall is important for stability of the unit and safe operation.