NOCO Genius BOOSTMAX GB500 Guía De Usuario página 8

Troubleshooting
Error
Error LED: Solid Red
Error LED: Single (1) Flash
Error LED: Double (2) Flash
Error LED: Triple (3) Flash
Error LED: Quadruple (4) Flash
Error LED: Quintuple (5) Flash
Hot LED: Solid
Hot LED: Flashing
Hot LED: Flashes Then All LEDs
Off
Cold LED: Solid
Cold LED: Flashing
Cold LED: Flashes Then All LEDs
Off
Technical Note
Reason / Solution
Reverse polarity detected. / Reverse the battery connections.
Short Circuit detected on battery clamps. / Remove all loads, reconnect clamps to battery.
Jump Starting period greater than ten (10) minutes. / Power "Off" the unit, then power "On".
Internal master switch failure. / Ensure the voltage selection knob is correctly positioned in the 12V or
24V position.
Bad battery cell detected during charge. / Power off unit, contact NOCO support.
XGC OUT overcurrent error. / Remove load from XGC OUT, then Power "Off" the unit then power "On".
Unit is fully operational, but approaching upper temperature limit. / Allow the unit to cool.
Unit is too hot to jump start, but other functions are still available. / Allow the unit to cool.
Unit is too hot to jump start or use other functions. / Allow the unit to cool, and bring the unit into cooler
environment.
Unit is fully operational, but approaching lower temperature limit. / Allow the unit to warm up.
Unit is too cold to jump start, but other functions are still available. / Allow the unit to warm up.
Unit is too cold to jump start or use other functions. / Allow the unit to warm up, and bring the unit into
warmer environment.
Lithium-ion batteries self warm when used. If the Cold Error LED is illuminated, attempt jump starting
multiple times to warm the battery and remove the error. Typically, 3-4 jump starts are suffient to warm
the battery and remove the error.