Extel PASF 10005 Manual De Uso página 53

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 60
The green LED will come on at the beginning of a call and goes out when the call
is ended.
The red LED near the
need replacing. The handset will also beep repeatedly. Press "STOP" to stop the bee-
ping.
The red LED will continue to flash until you replace the batteries in the electronic box
and turn off then on the handset (" I" switch) or an outside call is received.
The red LED near the
The handset will also beep repeatedly. Press "STOP" to stop the beeping then place the
handset on its base to recharge the battery.
The red LED on the base should light up. If not, make sure the adapter jack is proper-
ly inserted into the charging base and the adapter is properly inserted into the wall
socket.
The red LED near the
stop) a few seconds after the handset is placed on its charging base (this does not
mean the battery is charged; you must leave the battery on its base for at least 10
hours). Maximum performance will be obtained after several charge / discharge
cycles.
Caution :
The handset LEDs will not come on if the battery is completely discharged.
If in doubt, press the Answer button once
do not come on, the battery is still charged. After being fully recharged, the handset battery
has a life in standby mode of around 48 hours. The handset does not need to be left on its
base continuously, although doing so will not damage the battery.
Answer
button
HANDSET LEDS
symbol will flash when the batteries in the electrical box
symbol will flash when the handset battery needs recharging.
symbol will stop flashing automatically (the beeping will also
STOP
Open button
End Call
for electric
button
strike plate or
lock and ope-
ner with
option
ADSF 10003
WE
. If the handset beeps 3 times but the LEDs
Status LED
for the batte-
ries in the
electronic
box
GB
9
Handset
battery
charge LED

Publicidad

Tabla de contenido
loading

Tabla de contenido