Using The Appliance - Marta MT-1103 Manual De Instrucciones

USING THE APPLIANCE

FILLING THE WATER TANK

Unplug the steam iron.

Set steam selector to «OFF» position.

Open water tank lid.

Pour water slowly into water tank with measure cup. Don‟t exceed «MAX» mark.
 Close the lid.
NOTE: Use only tap water. Don't use chemical additives, scented substances and decalcifiers. That could damage the appliance.
TEMPERATURE SETTING

Sort the fabric before ironing. Check the marks on cloths labels.

Start ironing with clothes which require low temperature ironing. Iron takes less time to heat up than to cool down.

If fabric is mixed (e.g. 60% synthetics, 40% cotton) set the thermostat to the temperature of the fibre which requires lower temperature.

Set the thermostat to position with fabric requires. The light indication is on while the appliance is heating up. When the iron reaches operational temperatire the light is off. You can start ironing.
Mark Fabric
Synthetic
Silk/Wool
Cotton/Linen
STEAM IRONING

Unplug the appliance.

Set steam selector to «OFF» position.

Open water tank lid.
 Pour water slowly into water tank with measure cup. Don‟t exceed «MAX» mark.

Close the lid.

Put the iron in a vertical position.

Plug the appliance in.

Set temperature with thermostat according to signs on clothes label.
 Wait till light indication is off. That means that the appliance reaches operational temperature.

Set steam selector to required position.
NOTE: The iron gives off steam continuously only if it is hold horizontally and if you use high temperature setting. If the temperature is not high enough the steam is not vapourized and
water could leak from the soleplate's holes.

To cancel steam ironing set steam selector to «OFF» position.
CAUTION: Steam temperature is extremely hot! Avoid any contact with steam or hot water!
Thermostat mode
·
low temperature
··
medium temperature
···
high temperature
Forbidden to iron
12