SBS TEEARSETBT820K Manual De Instrucciones página 3

UK
INSTRUCTIONS
Warning: fully charge the headset before using it, by using
the supplied USB cable.
1. Power on: Slide the swich in ON position, the blue LED
will flash 3 times and beep a sound.
2. Power off: in standby mode, press and hold the
multifunction button until the red LED flashes once: a
beep sound.
3. Pairing: when device off, press the multifunction button
about 7 seconds, until the LED blue and red flash
alternately. Turn on your Bluetooth device and set it on
research mode: when the devices will be connected to the
headset, it beeps.
4. Answer a call: in telephone connected mode, press the
multifunction button once, the headset beeps.
5. Hold a call: during the call, press quickly once the
multifunction button until the headset emits a signal.
6. Rejecting a call: press about 2 seconds the multifunction
button. It emits a signal.
7. End a call: during the call, press the multifunction button.
8. Call last number: press the multifunction button twice,
the headset will emit a signal.
9. Voice call: in stand-by press and hold the (+) (-) at the
same time, you can voice dial (only for phones that
support this feature).
10. Microphone mute: in line, press (+) (-) about 2 seconds,
the LED flashes blue and red 2 times, the earset will emit
a signal.
11. Last/next song: while listening to music, press and hold
(+) to advance, press and hold (-) for the previous track.
12. Switch off: after 10 minutes without connecting the
headset switches off.
3