Numark NS7 Guia Del Usuario página 20

11. Auto-Loop Buttons: These eight buttons correspond to the deck's eight pads while in
Auto-Loop Mode. In that mode, press one of the pads to trigger an auto-loop of the
corresponding length. See
12. Effect Name: In Multi-FX Mode, the view will show three effects with one parameter knob
each.
In Single-FX Mode, the view will show one effect name with three parameter knobs.
To switch between Single-FX Mode and Multi-FX Mode, press and hold Shift and press
the Beat button.
To move to the next effect (in either mode), press and hold Shift and then press the FX
Button under the effect name. Alternatively, press and hold Shift and then turn the FX
Knob under the effect name to move quickly through the list.
13. Effect Parameter: In Multi-FX Mode, the view will show three effects with one parameter
knob each, which corresponds to the main parameter of that effect. To adjust each effect,
turn the FX Knob below it.
In Single-FX Mode, the view will show one effect name with three parameter knobs. To
adjust each parameter, turn the FX Knob below it.
To switch between Single-FX Mode and Multi-FX Mode, press and hold Shift and press
the Beat button.
14. Effect Beats Multiplier: This number determines the timing or rate of the effects, based
on the BPM.
Waveform View
This view contains the currently playing segments of the waveforms on the active decks. To
switch which waveform is shown, press the Layer button for each deck. The waveforms will
scroll by as the audio playhead moves through the track.
The waveforms are color-coded according to the frequency of each area: red indicates low
(bass) frequencies, green indicated mid-range frequencies, and blue indicates high (treble)
frequencies.
In each waveform, hot cue points are represented by triangles at the top and bottom of the
waveform, and loop regions are represented by shaded-blue sections.
Top Panel > Pad Mode Controls > Auto / Roll to learn more.
20