Maintenance And Inspection; Warranty Claims - Atlantic TIDALWAVE TWVSC Manual De Operación

Press the power
blink. Use the up
selected the hour, press the
Use the up and down
When you are satisfied with the programed START time press the
small OFF will be displayed on the left of the screen and a large OFF will be flashing in
the center of the screen.
OFF. Press the power
blink. Use the up
selected the hour, press the set
Use the up and down
your selections, wait ten seconds and the VSC will return to time of day display,
indicating that programming was entered.
To deactivate the START/STOP timer features, repeat the programming steps and press
the power button when the START and STOP times are flashing. The time will be
replaced with a large OFF, indicating the timer is deactivated.

Maintenance and Inspection

Regular maintenance and inspections are recommended to determine that everything
is operating properly. If any abnormal conditions are noticed, refer to the section on
Troubleshooting and take corrective measures immediately.
Winterization
The control panel should be removed and stored inside to protect it during the winter.
Please refer the specific winterization instructions for the pump installed with the
TidalWave VSC.
Warranty
The TidalWave Variable Speed Controller carries a three-year limited warranty. This limited
warranty is extended solely to the original purchaser commencing from the date of
original purchase receipt and is void if any of the following apply:
• The VSC was used in conjunction with a magnetic induction or direct drive pump.
• The VSC was not run on a dedicated circuit.
• The cord has been cut or altered.
• The VSC has been misused or abused.
• The VSC has been disassembled in any way.
• Serial number tag has been removed.

Warranty Claims

In case of warranty claims, return the VSC to the place of purchase, accompanied by the
original receipt.
button to activate the START timer. The hour will begin to
and down
set button and the minutes will begin to blink.
SET
buttons to select the minutes.
This indicates that the STOP timer is currently turned
button to activate the STOP timer. The hour will begin to
and down
button and the minutes will begin to blink.
SET
buttons to select the minutes. Once you are satisfied with
buttons to select the hour. After you have
SET
buttons to select the hour. After you have
set button. A
5