Tabla de contenido
Publicidad
10
X32 CORE DIGITAL RACK MIXER
X32 CORE DIGITAL RACK MIXER Controls
(1) (3) (4) (5) (6)
(7)
(2)
(12)
(8)
(9)
(10)
(11)
(13)
(14)
(15)
(16)
(17)
(18)
11
Quick Start Guide
Step 2: Controls
(1) SCENE/SETUP button toggles between
(EN)
Scenes Recall (green LED) and Channel
Selector mode (LED off) with a short press.
Hold the button to enter Setup Mode
(green LED) and press the button again
to exit Setup Mode. The LED turns red to
indicate access on attached DATA/AUDIO
USB media.
(2) DATA/AUDIO input allows connection of
USB flashdrives for firmware updates,
loading/saving scenes and show files,
and playing back or recording WAV files.
(3) METER displays the input level of the
selected channel.
(4) DISPLAY shows the channel name and icon,
scene name, or setup page information.
(5) CHANNEL TYPE LEDs indicate which type of
channel is currently selected.
(6) SELECT knob navigates the display menus
and edits setup parameters. See the SELECT
Knob Functions section for details.
(7) TALKBACK button engages the external
Talkback mic input on the rear panel.
Details of the routing and operation can be
defined on the monitoring preferences page
of the control software.
(8) USER ASSIGNABLE ENCODERS adjusts
a predefined variable parameter in
the software. Function to be defined in the
control software.
(9) USER ASSIGNABLE BUTTONS toggles
a predefined on/off parameter in
the software. Function to be defined in the
control software.
PHONES output and level allow audio
(10)
to be monitored directly from the unit.
Details of the audio content can be adjusted
in the monitoring preferences page of the
control software. While in Channel Select
Mode, push the Select encoder to toggle
Solo on and off.
POWER button turns the unit on and off.
(11)
X-USB interface card allows up to
(12)
32 channels of bidirectional audio to be
transmitted to and from a computer.
ETHERNET connector allows full OSC-based
(13)
remote control of the X32 CORE.
MIDI IN/OUT allows the unit to send and
(14)
receive MIDI commands via standard 5-pin
DIN cables.
ULTRANET connector sends 16 channels of
(15)
audio to a P16 monitoring system.
AES50 A and B connectors allow 96 channels
(16)
of bidirectional audio for connection to S16
digital snakes or other X32 family products.
The front panel LEDs will light green to
indicate proper sync, light red to indicate
a sync error, and remain unlit when no
connection is present. Shielded CAT-5e
cable should always be used for AES50
connections between X32 and S16 units.
MONITORING OUTPUT jacks allow connection
(17)
of monitor speakers via balanced or
unbalanced 1/4" cables.
TALKBACK input accepts a dynamic
(18)
microphone via 1/4" TRS jack. Adjust the gain
with the adjacent TRIM knob.
Publicidad
Tabla de contenido
