Description; Front Keyboard; Display Indications; Operating Modes - ORTEA NEXT Icar RPC 5LGA Manual De Operación

WARNING!
Carefully read the manual before the installation or use.
This device must be installed by qualified personnel, in compliance with current rules and regulations, in order to avoid damages or safety hazards for
people and belongings. Before any maintenance operation on the device, cut off the voltage from measuring and supply inputs and short-circuit the Current
Transformer input terminals. Thhe Manufacturer shall not be held liable in case of incorrect use of the device.
Products illustrated herein are subject to alteration and changes at any moment and without prior notice. Therefore, technical data and descriptions in the
document do not have any contractual value..An interrupting device must be installed close by the equipment and within easy reach of the operator.
The device must be marked as the disconnecting device of the equipment (IEC EN 61010-1).
1

DESCRIPTION

Automatic power factor controller.

Flush-mount, standard 96x96mm housing.

Backlit LCD screen.

 5 relays, expandable to 7 max.
4 navigation keys for function and settings.

Alarm messages in 6 languages.

Expansion bus with 1 slot for expansion modules:

RS232, RS485, USB communications interface.
o
Additional relay outputs.
o
High accuracy TRMS measurements.

Wide selection of electrical measures, including voltage and current THD with harmonic analysis up to 15th order.

 Voltage input separated from power supply, suitable for VT connection in medium voltage applications.
Wide-range power supply (100-440VAC).

Front optical programming interface: galvanically isolated, high speed, waterproof, USB and WIFI dongle compatible.

Programming from front panel, from PC or from tablet/smartphone.

 2-level password protection for settings.
Backup copy of original commissioning settings.

Built-in temperature sensor.

Tool-less panel mount.

2

FRONT KEYBOARD

key Selects among available measurements. Used also to access programming menus.
  keys Sets values and selects steps.
key Selects operating mode between manual and automatic.
3

DISPLAY INDICATIONS

4

OPERATING MODES

4.1 MAN AUT
AND MODES
The icons AUT and MAN indicate the operating mode automatic or manual. To change the mode, press and hold the
key for 1 second. The operating mode remains stored even after removing and reapplying the power supply voltage.
4.2 MAN
MODE
When the unit is in manual mode, you can select one of the steps and manually connected or disconnect it. In addition to
the specific icon, the alphanumeric display shows
the other measurements as usual. While the display shows
select a step, use the ▲or ▼keys. The selected step will flash quickly. Press
step. If the selected step has not yet exhausted the reconnection time, the
has been accepted and will be conducted as soon as possible. Manual configuration of the steps is maintained even when
the power supply voltage is removed. When the power returns, the original state of the steps is restored.
ALL75 mar19
Inductive /
Manual
mode capacitive
Main
display
Bar graph
Secondariy
display
in order to highlight the manual mode condition. Press
MAN
Automatic Cooling fan
mode status
Step status
Active alarm
Alphanumeric
, it is possible to select the step to be switched on or off. To
MAN
icon will flash to indicate that the transaction
display
to activate or deactivate the selected
ENGLISH
to view
11 / 40